Product description
Pistol designed for polyurethane foam applications. High quality – thanks to the use of appropriate quality grades of stainless steel, aluminum and brass. Elements most exposed to dirt and damage due to the aggressive action of foams and corrosion have been additionally secured with a PTFE coating.
Destination / Application
The pistol makes it easy to carry out such tasks as: sealing, window and door assembly, filling gaps in insulation, sealing and insulation of partition walls, and insulation of walls and roofs.
How to use
Usage:
1. Getting Started
– Strongly shake the foam container, for about 15 seconds.
– Screw the adjusting screw on the back of the gun as far as it will go to stop the trigger.
– From the foam container, remove the cap and then screw the container to the gun nut for a noticeable resistance.
– Then, turn the adjusting screw on the back of the gun by turning to the left until the threaded part of the adjusting screw appears – the screw thread of the adjusting screw should remain screwed into the gun body.
– Press the trigger lever and fill the gun with foam.
– The gun is ready for use.
– The foam stream comes out by pressing the trigger lever.
– Releasing the trigger lever causes the foam to stop flowing.
– The volume of the mounting foam flux is controlled by turning the adjusting screw.
2. Activities after work
Screw the adjustment screw as far as it will go to stop the movement of the trigger lever.
It is advisable not to unscrew the foam cartridge from the gun. Make sure that the gun is always screwed, but partially filled, to keep the foam inside the gun under pressure. This prevents the foam from coughing inside the gun.
If the gun breaks for more than a month, clean the gun with the foam cleaner. Do not allow the foam to dry inside the gun. The dried foam can only be removed mechanically. Leaving the dried foam inside the gun, leads to irreversible pistol jam.
3. Re-use of the gun
Strongly shake gun with attached container, for about 15 seconds. Cut the tip of hardened foam with sharp knife. Loosen the adjusting screw to the left and release enough foam to make the stream uniform. After that, the gun is ready for use.
4. Replacing the container
If the foam is out of the container, replace it with a new one. To see if the container is completely clear, aim the nozzle toward the waste bin and press down on the trigger until the gun nozzle is fully open. Reassemble immediately, without cleaning the gun, new container and follow point 1.
5. Cleaning the gun
Unscrew the container from the gun. Place the spray tip on the spray cleaner and clean the remaining foam on the spray gun. Remove the spray tip and screw in the spray gun with a detergent. Proceed as in the case of a foam container (item 1). Fill the gun with detergent and leave for about 10 minutes. Press the trigger again and clean the inside of the gun with fresh detergent. Unscrew the cleaning container. Use a cloth to remove the remnants of the detergent from the joint of the container and the gun
And cover with a thin layer of Vaseline. Do not clean the gun with corrosive agents. For continuous use of the gun, clean the gun as described above every 2 to 3 months
Technical data
Index number YT-6743
EAN 5906083967436
Brand Yato
PCS unit
Gross Weight (kg) 0.5000
Master Carton MC 20
Pal 240
Material brass, stainless steel
Surface finish PTFE coating